To enable this driver, use the command: sudo modprobe 8192cuįinally, update /etc/modules with this command before you reboot: echo '8192cu' | sudo tee -a /etc/modules To compile and install the proprietary Realtek 8192cu driver, run the following commands in an open terminal: sudo apt-get update & sudo apt-get install git build-essential linux-headers-generic dkms Your wireless driver should start up automatically. You can use the wireless now or, alternatively, you can make sure you have all of your work saved before you type: sudo reboot Then, edit /etc/rc.local by opening the file with your favorite text editor like in this example: sudo gedit /etc/rc.local (use these instructions when your wireless USB device is not automatically recognized by Ubuntu) sudo modprobe rtl8192cuĮcho "2001 330D" | sudo tee /sys/bus/usb/drivers/rtl8192cu/new_idĮcho "rtl8192cu" | sudo tee -a /etc/modules :: Unable to build linux-xanmod - makepkg exited with code: 4Įdit: the solution is in my comments below.12.04 & 14.04+: you can view these instructions or just do as I say. Thanks! : Fatal error: can't close drivers/net/wireless/realtek/rtlwifi/rtl8192cu/dm.o: No space left on device There's like 23 GB available on the / partition and 200+ GB available on the /home partition. I considered the possibility that the issue is due to disk space but I don't believe so. Is there way to have it skip compiling wireless drivers that I do not need and if not, how do I go about resolving this? This desktop does not have a wireless card, just the integrated intel NIC on the motherboard. The error is pasted below but the gist of it is that it gets to realtek wireless drivers and fails because, if I'm reading it right, it apparently is trying to write 24 bytes to the device but the device isn't on my machine so it can't write anything, I'm assuming.
I've installed xanmod several other times on ubuntu in the past and it takes like 2-3 hours but it completes correctly.
0 kommentar(er)
